QUINCY HYDRONIC TECHNOLOGY Riva FP Installation Manual download pdf (Page 26)

26 RIVA PLUS MANUAL

11. Electrical Connections/Wiring

Figure 11.1

Removing Front Panel:

• Remove the front panel by removing screws A

and sliding the front panel up and away from

the boiler

Removing Side Panel:

• Remove screws B

Figure 11.2

Removing Control Panel:

• Remove screws C.

Figure 11.3

• Move the lower part of the side panels (ﬁ gure

12.3).

• Pull the control panel. When completely pulled

out, the panel can rotate 45° downward.

Figure 11.4

• Loosen screws D and remove the service

panel (Fig. 12.4).

11.1 Power Connection:

For the electrical connection to the boiler use electric wires which conform to local regulations.

The boiler, when installed ,must be electricallybonded to ground in accordance with the require-

ments of the authority having jurisdiction or, in the absence of such requirements,with the National

Electrical Code,ANSI/NFPA 70 and/or Canadian Electrical Code Part I CSA C22.1, Electrical Code.

In the USA, maintain a clearance of at least 4ft horizontally from the vent terminal to gas meters,

electric meters, regulators and relief equipment. In Canada, maintain a 6ft clearance between the

vent terminal and these devices.

11.2 Connection to the electricity supply:

• Connect the electrical supply cable coming from the fused spur isolation switch to the power supply terminal block

of the boiler (as shown in ﬁ gure 12.5) keeping the same connections for the live wire and the neutral wire

Figure 11.5

• Connect the earth wire(yellow/green). Boiler must be wired directly to earth ground on breaker panel.

WARNING

Note: Do not connect live wires to

thermostat terminals 1-3.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 47 48

No comments

QUINCY HYDRONIC TECHNOLOGY Riva FP Installation Manual Page 26